(800) 478-7801

JD GPS CAN Programming Cable Installation

If you purchased a Retrofit kit with CBL 100017 refer to "Universal Power Cable Retrofit" to update your power cable before installing the CAN programming cable.

Locate ISO BUS connector by the tractor hitch.

Disconnect black 4 pin connector on the back

Install Rust Sales ISO-T PN DAC-7000-ISO-T inline.

Connect 3 pin CAN extension from ISO-T to triangular blue connector on your universal power cable.

Once you have the connections made the globe mounted on the scraper will be displayed on the monitor in your tractor.

If you are using steering at the same time make note of the serial number of the second globe when it shows up on your tractors monitor.

It is best practice to disconnect the scraper globe from the CAN system after making programming changes.